My latest aquisition...

Larry · Post by **Larry** » Sun Feb 08, 2015 1:30 am

https://a4-images.myspacecdn.com/images ... 00x300.jpg

Excel Mach3
Arrived the other day. All in superb condition and complete. I've had one of
these for the last nine or so years, but it was a bare board, in very ordinary
condition. I remember having to melt a soldered joint to get it working
properly. But at $20 I could hardly complain.
This one cost quite a bit more! If Fidelity had not got greedy with the prices
we would have a lot more of these in circulation.I'm partial to the earlier
LED bedside clock style displays. They don't lose their contrast over time and
give ample information.
L

Wardy · Post by **Wardy** » Mon Feb 09, 2015 12:26 pm

Congrats Larry!

Larry · Post by **Larry** » Mon Feb 09, 2015 5:24 pm

Wardy wrote:Congrats Larry!

Thanks Paul. You don't happen to have a spare Excel Mach4 laying
around that you might like sell, do you?
Or are they mythical, existing only in the imaginations of collectors?
L

Post by **Steve B** » Mon Feb 09, 2015 6:19 pm

Larry wrote:
Wardy wrote:Congrats Larry!
Thanks Paul. You don't happen to have a spare Excel Mach4 laying
around that you might like sell, do you?
Or are they mythical, existing only in the imaginations of collectors?
L

lol
actually I have two of these
well...kinda sorta
one of them is a factory upgrade of the Excel Mach III
it has all of the correct hardware for the ExMach IV and I have tested it against my original EXMach IV.. but sadly ..the model label still shows it as an Excel Mach III(6098) not Excel Mach IV(6110)

Oh Well Regards
Steve